Stephenson K2 Buffer Pedal:

Features:

  • High impedance fet input (simulates the front end of a good old tube amp)
  • Fet buffered tuner output (always active)
  • Fet buffered FX loop send
  • Left (mono) FX loop return
  • Right FX loop return
  • Amp #1 output
  • Amp #2 isolated phase reversible output
  • Mute footswitches with LED's for amps 1 & 2
  • Master ground lift switch

 

The K2 Buffer pedal is designed for the guitarist who uses two amps at the same time. The K2 addresses the issues of ground loops, guitar pick-up loading, and hum problems when two amps are used.

User comment:
"Hi Mark - Just picked up the pedal and plugged everything in. Absolutely wonderful. No hums or buzzes and i love the retina burning LEDs. Great workmanship and the switching is dead silent. Right away the tone was open and present on the amps (like plugging right in from 5 feet away) with no difference on cable lengths or anything, and i got all kinds of different textures using the two amps within a few minutes of fooling around... this is going to be amazing in the studio. I then plugged my pedal board in to the loop as is and was amazed at how everything sounds richer and more open... i hadn't realized how much i was loading the pickups and killing tone with the one compressor that isn't true bypass and the volume pedal/tuner combination. This is only going to get better as i rewire and incorporate everything properly. Thank you for the great work Mark. This pedal is taking my setup to a whole new level and i'm getting tone goosebumps again, and that just makes me want to play more."

 

 

Contact Info :

STEPHENSON AMPLIFICATION

Mark Stephenson
PO Box 176
Parksville, BC
CANADA
V9P 2G4

Tel: 250-954-2292
Monday to Friday 10:00 AM - 6:00 PM Pacific

stephenson@telus.net